These systems pump heat-transfer fluids (usually a glycol-water antifreeze mixture) through the solar water heater. Heat exchangers transfer the heat from the fluid to the water that is stored in tanks. Double-walled heat exchangers or twin coil solar tanks prevent contamination of household water. Some standards require double walls when the heat-transfer fluid is anything other than household water. Closed-loop glycol systems are popular in areas subject to extended subzero temperatures because they offer good freeze protection. However, glycol antifreeze systems are more expensive to purchase and install and the glycol must be checked each year and changed every few years, depending on glycol quality and system temperatures.

Drainback systems use water as the heat-transfer fluid in the collector loop. A pump circulates the water through the solar water heater. When the pump is turned off, the solar water heater drains of water, which ensures freeze protection and also allows the system to turn off if the water in the storage tank becomes too hot. A problem with drainback systems is that the solar water heater installation and plumbing must be carefully positioned to allow complete drainage. The pump must also have sufficient head pressure to pump the water up to the collector each time the pump starts. Electricity usage is therefore slightly higher than a sealed closed or open loop.

Passive systems move household water or a heat-transfer fluid through the system without pumps. Passive systems have the advantage that electricity outage and electric pump breakdown are not issues. This makes passive systems generally more reliable, easier to maintain, and possibly longer lasting than active systems. Passive systems are often less expensive than active systems, but are also generally less efficient due to slower water flow rates through the system.

Thermosiphon Systems
A thermosiphon system relies on warm water rising, a phenomenon known as natural convection, to circulate water through the solar absorber and to the tank. In this type of installation, the tank must be located above the absorber tubes/panel. As water in the absorber heats, it becomes lighter and naturally rises into the tank above. Meanwhile, cooler water in the tank flows downwards into the absorber, thus causing circulation throughout the system. This system is widely used with both flat plate and evacuated tube absorbers. The disadvantages of this design are the poor aesthetics of having a large tank on the roof and the isses with structural integrity of the roof. Often the roof must be reinforced to cope with the weight of the tank.

Batch Heaters
Batch heaters are simple passive system consisting of one or more storage tanks placed in an insulated box that has a glazed side facing the sun. Batch heaters are inexpensive and have few components, but only perform well in summer when the weather is warm. Evacuated tube solar collectors are now an affordable and much more efficient alternative to either batch or flat plate collectors.